If the peanut oil press equipment we purchased does not operate normally, or breaks down, it will cause great trouble to our production. We must know that the machine is always broken, so how to maintain and repair the oil press has become a problem that many buyers need to solve.
Sometimes even if the parts are broken, we have to buy and sell parts, so no matter whether there is a problem with the peanut oil press we bought, we must know how to maintain and maintain the peanut oil press in case of emergency. In this way, if the peanut oil press breaks down, we can troubleshoot it ourselves, so as to resume production in the shortest possible time.
The new peanut oil press developed by BTMA is specially tailored for small and medium investors in the oil extraction industry. It has won high-quality feedback from customers with its low price and super high oil yield.
No matter what kind of mechanical equipment, no matter how good the quality is, after a long period of overloading, without timely maintenance and maintenance, some minor faults will inevitably occur, and the peanut oil press is no exception.
In the face of equipment that goes on strike due to failure, what we need to do is to troubleshoot and resume production as soon as possible, so as to reduce the loss to nothing. Usually, when the equipment breaks down, the first thing everyone thinks of is to contact the manufacturer for consultation, but the long-distance water cannot quench the near-thirst. Then let’s summarize the causes and treatment methods of common faults of peanut oil press:
1. Troubleshooting method for oil leakage of peanut oil press cylinder and piston: There are two reasons for this failure, the first is caused by the wrong installation of the peanut oil press cup bowl mouth upwards, and the second is caused by the rupture and damage of the cup . If it is the first case, reinstalling the cup can eliminate the fault. In the second case, the cracked or damaged cup needs to be replaced.
2. Troubleshooting method for peanut oil press oil pump not absorbing oil: If the oil pump does not absorb oil caused by dirt blocking the oil filter, the oil filter should be removed and washed. If the oil has been used for a long time, the sediment will adhere to the oil inlet valve, which will cause the valve to not seal tightly and the oil pump of the screw press machine will not absorb oil. In this case, replace the new oil or release the old oil to filter and clean the oil inlet valve. If the amount of oil in the oil tank is insufficient, just add enough oil to the oil tank. If there is no vacuum in the oil pump, you can pull out the small piston, inject oil and then press.
3. Troubleshooting method for insufficient pressure of peanut oil press oil pump:
Insufficient pressure of the oil pump may be caused by dirt or poor sealing of the valve. It can be disassembled and washed and ground to make it tight. It may also be that the screw plug of the oil inlet valve of the oil press equipment is in poor contact with the valve seat, and it also needs to be disassembled and washed to make it tightly sealed. The third possibility is that the screw plug of the inlet and outlet valve of the oil press is in poor contact with the valve seat or is not tightened to cause oil leakage. You can grind the screw plug and valve seat of the oil inlet valve on the oil press to make it close or tighten the screw plug. The last possibility is that the gap between the small piston and the pump body is too large after wear and tear, and a new pump should be replaced.
Therefore, the above BTMA Machinery analyzes the causes of the three most common faults of peanut oil press equipment and introduces the corresponding solutions. As long as you follow our method and be careful when troubleshooting, you can usually solve them easily. Troubleshooting can resume production in the shortest possible time.