Installation of palm oil press accessories

Different palm oil presses have different installation tools, and the steps are the same. This time, we take the  palm oil press as an example to explain the installation essentials of palm oil press accessories.

Screwdriver installation

Stand up the squeeze snails with their thin ends upward, install the retaining rings, install the squeeze snails on the shaft in sequence from No. 1, and then press them tightly with lock nuts to prevent the oil residue from penetrating into the squeeze screw holes and affecting the performance of the squeeze snails. Disassemble. (Adjust the nut so that the two ends of the adjusting bolt are 8309 bearings. When installing, the large hole surfaces of the two bearings are all against the two ends of the adjusting bolt. After the squeeze screw is assembled as a whole, use two (M42×2) nuts to tighten the back. Pay attention to the gap between the two 8309 bearings. Turn the adjusting bolt by hand until you feel that the rotation is flexible.

Installation of strips

Stand up the strips in a circle, and place the oil tank facing down (it is recommended to put a wooden board below), and arrange the strips neatly one by one on the inner wall. The end with the deep oil groove faces down, and the deep oil grooves of the two rows cannot be put together facing each other. The last row is driven in with a metal rod. If the row is loose, an iron sheet can be added between the rows so that the row is close to the inner wall until there is no protrusion on the inner wall by hand.

Installation of press cage

Put the strip row circle with the oil outlet groove facing the frame, and then put it into the round row row according to the sequence number of the circle. Bring out the sump with the side facing the frame. Then use the compression nut to tighten a few buckles to lean against the round row, and install the squeeze cage. (The upper and lower press cages are made in pairs, and the upper and lower cages must be replaced together if they are replaced.) Use the removed bolts to tighten them alternately one by one.
Disassembly of palm oil press accessories
Different palm oil presses use different tools for disassembly, and the steps are the same. This time, we take the palm oil press as an example to explain the disassembly essentials of the palm oil press accessories.

Screw removal

Immediately after stopping the machine, move the handle, pull out the press shaft from the press chamber, remove the protective cap, hexagonal nut, round nut and adjusting bolt, insert an iron rod with a diameter of 16 into the hole of the lock nut and rotate clockwise (remember to The threads matched with the shaft core are all left-handed), after removing the locking nut, each section of the squeezing screw can be removed. If the squeezed snail (with fine slag in the inner hole) is not easy to disassemble due to blockage, you can put a wooden board on the ground, and two people can lightly bump the squeezed snail a few times to remove it. If it still cannot be removed, use wood fire to heat it up. remove.
strip disassembly
To remove the rib ring, use one end of the iron rod to touch a row from the side, and tap the other end with your hand to knock out one row, and the rest will automatically loosen.