Correct disassembly and installation steps of oil press strip

The most critical equipment for the production of vegetable oil is the oil press. The press strip is an important wearing part of the oil press. Due to the friction and extrusion of oil crops, the wear is very serious. According to one pressing method, each set of pressing strip is used less than a month on average to scrap. The following details of the oil press press strip disassembly method:

Removing and assembling steps of oil press strip:

1. Disconnect the power supply of the oil press and remove the conductor and thermocouple on the heating ring.

2. Loosen the screw of the oil press and remove the main shaft from the machine.

3. The press ring and press assembly of the oil press are slowly removed from the machine.

4. With the impact force, the two positions of the same square pressing strip is washed out of one, and the rest are automatically scattered. If the pie mouth needs to be replaced, the protruding edge of the pie can be gently hit, and the pie mouth can be unloaded.

5. Clean the inner hole of the press strip and the press strip ring from the oil press, replace the wear parts, and put them in accordance with the direction and order laid, not mixed with the new Beijing Guburn press strip.

6. Erect the oil press press ring, find a and the same thickness as the main shaft, press the length of the similar internal die vertical in the middle of the press strip (not very suitable for a wooden pile can also be done), and then press the press strip according to the unloading direction will press an octet press strip and a four Angle press strip alternately into, after playing four Angle press strip, into the pour the edges, not too tight, But also can not be too loose, in the assembly process, to hammer other pressing strip end face, so that it is tight, all into the hammer pressing strip to make it neatly close to the inner wall of the pressing strip ring, with the hand touch the inner wall of the pressing strip without protruding phenomenon.

7. Put the press ring on end and insert it evenly into the press strip.

8. Problems that should be paid attention to when assembling Beijing Solid press strips:

(1) To divide the four corners of the oil line, check that the order of the long oil line is from the start of the feeding end, gradually transition from the large oil line to the small oil line, the other group of oil line direction should be the same.

② When the oil press is too tight or too loose, the size of the octagonal press can be adjusted.

9. After the oil press is installed, the two end faces are inverted and then driven into the front support and the back support. When the two sides are played evenly, the front support side and the back support side should be in line; Otherwise, after playing, the two holes of different hearts can not wear the tie rod, the press strip before and after the support are installed, but also to check whether there is a protruding phenomenon of the inner wall of the press strip, if there is to knock.